Lbl-lighting 2-Circuit MO Rigid Standoff Manual de usuario descargar pdf

Installation Instructions for

Telescoping Rigid Standoffs

1.1

HANGER-ADJ-_-2(-BJ)

980MR2TSP

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor dry locations only.

This product must be used only with LBL 2-Circuit Monorail or

LED-Illuminated Monorail systems.

This instruction is for the following models:

Monorail Support 2.5" - 4" (HANGER-ADJ-_1-2)

Monorail Support 6" - 10" (HANGER-ADJ-_2-2)

Monorail Support 12" - 24" (HANGER-ADJ-_3-2)

Monorail Support 24" - 48" (HANGER-ADJ-_4-2)

Monorail Support 48" - 96" (HANGER-ADJ-_5-2)

Above model numbers with -BJ suffix (vaulted ceilings).

Install the Ceiling Anchor

2-Circuit Monorail

ANCHOR

Select a location on the ceiling where the Monorail is to be

mounted.

One way of marking the standoff locations on the ceiling is to

lay the Monorail on the floor underneath of the selected

location and by using a plumb bob pointing on the center of

the Monorail, mark the points on the ceiling.

Another way is to hold the Monorail directly against the ceiling

and mark the standoff points on the ceiling.

Tap the anchors at the marked points up to the threaded

portion with a hammer.

Screw the anchors in the rest of the way with a Phillips

screwdriver.

Insert the #8 screw into the threaded nipple and washer.

Tighten the #8 screw completely into the anchor to secure the

washer and threaded nipple.

Repeat these steps for each standoff.

ANCHOR

WASHER

#8 SCREW

THREADED NIPPLE

CEILING

1B1C

1 2 3 4

Indice de contenidos

Pagina 1 - Telescoping Rigid Standoffs

Installation Instructions forTelescoping Rigid Standoffs1.1HANGER-ADJ-_-2(-BJ)980MR2TSP1GP I :ENERAL RODUCT NFORMATIONThis product is suitable for ind

Pagina 2

2Loosen the M4 set screw on the support(Do Not Remove)post with the 2 MM Allen wrench provided and remove thesupport post.2 MM ALLEN WRENCHM4 SET SCRE

Pagina 3 - HOUSING CAP

Install the 2-Circuit MonorailRemove the housing cap on all standoffs.1HOUSING CAPPlace a section of the Monorail into standoff housings.While support

Pagina 4 - SAVETHESE INSTRUCTIONS!

Comentarios a estos manuales

Sin comentarios

Lbl-lighting 2-Circuit MO Rigid Standoff Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Lbl-lighting 2-Circuit MO Rigid Standoff. LBL Lighting 2-Circuit MO Rigid Standoff User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Lbl-lighting 2-Circuit MO Rigid Standoff