Lbl-lighting MO Bracket Manual de usuario

Busca en linea o descarga Manual de usuario para Encendiendo Lbl-lighting MO Bracket. LBL Lighting MO Bracket User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation Instructions for
Telescoping Rigid Standoffs with Wall Bracket
1.3
HANGER-ADJ-_-WB
980MRLCSP
1
Install the Telescoping Rigid Standoffs
ANCHOR
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL Monorail system only.
This instruction is for the following models:
Monorail Support 2.6" - 4" (HANGER-ADJ-_-1WB)
Monorail Support 6" - 10" (HANGER-ADJ-_-2WB)
Monorail Support 12" - 24" (HANGER-ADJ-_-3WB)
Select a location on the wall where the Monorail is to be
mounted.
Mark the standoff points on the wall.
Tap the anchor at the marked point up to the threaded portion
with a hammer.
Screw the anchor in the rest of the way with a Phillips
screwdriver.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple in place.
Repeat step 1 through 5 for the remaining standoffs.
ANCHOR
WASHER
#8 SCREW
THREADED NIPPLE
WALL
Monorail
1A
11
4
3
1B
2
3
1C
5
4
6
4
5
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - 980MRLCSP

Installation Instructions forTelescoping Rigid Standoffs with Wall Bracket1.3HANGER-ADJ-_-WB980MRLCSP1Install the Telescoping Rigid StandoffsANCHORGP

Pagina 2 - Install the Cable Post

2SUPPORT POSTLoosen the M4 set screw on the support(Do Not Remove)post with the 2 MM Allen wrench provided to remove thesupport post.2 MM ALLEN WRENCH

Pagina 3 - Install the Monorail

3Insert the aircraft cable completely into the slotted cable post.Pull the aircraft cable so that the strain relief sits against theslot.AIRCRAFT CABL

Pagina 4 - SAVETHESE INSTRUCTIONS!

4PLASTIC INSULATORMONORAILIf necessary (depending on design) rotate the Monorail to thedesired angle or horizontal position.Tighten the M3 set screw o

Comentarios a estos manuales

Sin comentarios