Lbl-lighting Onyx Teardrop Manual de usuario descargar pdf

Installation Instructions for

1.4

Install the Fixture

Loosen the M3 set screw on side of the(Do Not Remove)

onyx shade with the 1.5MM Allen wrench provided.

Remove the onyx shade.

M3 SET

SCREW

1.5MM ALLEN WRENCH

ONYX SHADE

BACKPLATE

CANOPY

M3 SET SCREW

1.5MM ALLEN WRENCH

Loosen the two M3 set screws on side of(Do Not Remove)

the canopy with the 1.5MM Allen wrench.

Remove the backplate.

GP I :ENERAL RODUCT NFORMATION

This product can mount to either a 4" square electrical box with

round plaster ring or an octagon electrical box.

This product is suitable for indoor dry locations only.

This product can be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

This instruction is for the following models:

Onyx Cylinder Wall (HW176ON_2G60)

Onyx Dome Wall (HW177ON_2G60)

OnyxTeardrop Wall (HW178ON_2G60)

Onyx Wall

HW17_ON_2G60

980ONYXW

1A 1B

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Wall

1 2 3 4

Indice de contenidos

Pagina 1 - Onyx Wall

1Installation Instructions for1.4Install the FixtureLoosen the M3 set screw on side of the(Do Not Remove)onyx shade with the 1.5MM Allen wrench provid

Pagina 2

Place the fixture canopy onto the backplate. Level the fixturevertically and tighten the two M3 set screws with the 1.5MMAllen wrench to secure the fi

Pagina 3 - Install the Lamp & Shade

LAMPSOCKETM3 SETSCREW1.5MM ALLENWRENCHONYX SHADEReplace the onyx shade onto the socket housing and tightenthe M3 set screw on side of the onyx shade w

Pagina 4 - SAVETHESE INSTRUCTIONS!