Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed Manual de usuario descargar pdf (Pagina 2)

Place all wires and wire nut connections inside the electrical

box.

Tighten the two provided #8-32 flat head screws to the

electrical box holes with the 3/32 Allen wrench to secure the

canopy in place.

#8-32 FLAT

HEAD SCREW

3/32 ALLEN WRENCH

Install the 2-Circuit Monorail to the

Power Feed Canopy

Push two 2-Circuit Monorail sections completely onto the

straight isolating connectors.

Tighten the M3 set screws firmly with the provided 1.5 MM

Allen wrench. the set screws whichDo Not Over Tighten

may strip the thread.

M3 SET SCREW

1.5 MM ALLEN

WRENCH

STRAIGHT ISOLATING CONNECTOR

2-CIRCUIT MONORAIL

NOTE: The standoffs should be installed to support the

2-Circuit Monorail while connecting 2-Circuit Monorail to

the power feed canopies. Refer to the instructions

provided with the standoffs.

Remove the power feed cap from the power feed housings.

Completely back out the screw on the power feed caps.

Loosen the knurled cap on both power(Do Not Remove)

feed housings and pull the middle contact wire slightly out so

that the middle contact is not exposed in both power feed

housings.

POWER FEED CAP

SCREW

POWER FEED

HOUSING

KNURLED CAP

MIDDLE

CONTACT

MIDDLE

CONTACT WIRE

1A2A

1A2B

1 1

1 2 3 4

Sin comentarios

Lbl-lighting 2-Circuit MO Direct Feed Canopy Dual Feed Manual de usuario Pagina 2